- AAS
- Access Products
- ACE
- Adams Rite
- AeGIS
- Aerotech
- AGW
- AiPhone
- All-O-Matic
- Alloy Castings
- Allstar
- Alvarado
- Ameriline
- Apollo
- BD Loops
- BEA
- Belden
- Bommer
- Byan
- Cansec
- CelAccess
- Click2Enter
- Codelock
- Cornerstone
- Counsel Industries
- Cyrex
- D&D
- DC Solutions
- Diablo Controls
- Ditek
- Doorking
- Duragate
- Eagle
- EbelCo
- Elite
- Elk
- EMX
- FAAC
- Gibcloser
- Guardian Hardware
- Guardian Traffic
- HID
- HySecurity
- International
- Kaba
- Kant-Slam
- Keedex
- Knox
- Kwikset
- Liftmaster
- Linear
- Locinox
- Lockey
- Lokk-Latch
- Master
- Miller
- MK Battery
- MMTC
- Modesto
- Morningstar
- Multicode
- Osco
- Papaiz
- PDQ
- Pedestal CEO
- PowerGuard
- Q-SEAL
- Ramset
- Reno
- Revere
- Ritron
- Rofu
- Schlage
- SEA
- Seco-Larm
- Securitron
- Sentex
- SIRIT
- Sunwise
- Transmitter Solutions
- Trine
- Ultra
- US Automatic
- Viking
- Yingli
- Zareba
Linear EXA-1000 Omni-Directional Remote Antenna
Category: Linear Delta3 Radio Remote Accessories
Image 1 of 1. Click image to enlarge.
Product Details
The Model EXA-1000 Omni-directional Remote Antenna is designed to enhance the radio range of Linear’s receivers. This antenna can be connected to the F connector on many Linear receivers to improve their range when they must be located in poor signal reception locations. Usually an increase of 20-30% range can be expected. The versatile EXA-1000 can be mounted in a variety of ways. A 2-inch U-bolt is supplied for post or pipe mounting, or the U-bolt holes in the Base Plate can be used to screw the antenna to a wall or vertical wood brace or beam.
NOTE: Generally, the higher the antenna is mounted above ground level, the better the radio range will be.
The EXA-1000 is a 1/2 wave, center fed, vertical antenna composed of three parts: an Antenna assembly with an F connector attachment; a Base Plate assembly with radial mounting provisions; and a five-foot, 75-ohm coaxial cable. The cable connects to the antenna base on one end and the receivers F connector on the other. If the antenna must be mounted further than five feet from the receiver, an extension cable of up to a maximum of 25 feet may be used instead of the five foot cable supplied. Because of the cable resistance, the performance of the EXA-1000 may be degraded by using longer than a 25 foot cable.
Features
• Compatible with all Linear receivers with Type F antenna connector
• Receives signals in 288 to 320 MHz range
• Omni-directional remote antenna
• Includes 5 feet of coax
• U-bolt for post mounting
• Dimensions: 3"w x 19.5"h x 6"d
Ratings Overview
(no rating information)| Operating Frequency: | 315 MHz |
|---|---|
| Data Format: | DX format |
| Number of Codes: | 1,048,575 |
| Number of Channels: | DXR-701, one channel; DXR-702, two channels |
| Measure Range: | 700 feet in one quadrant with DXT-21 transmitter; 500 feet in open air (four quadrant test) |
| Operating Temperature: | 32° to 140° F (0° to 60° C) |
| Sensitivity: | -95 dBm (typical) |
| Number of Stored Transmitter Codes: | 32 per receiver |
| Receiver Output: | For "C" relay contact, 1 amp, at 32 VDC per channel |
| Learn Mode: | Press and release to enter learn mode |
| Transmitters Learned: | Press and hold for five seconds after the last LED flash |
| Erase Memory: | Press and hold for five seconds after the last LED flash |
| Clear latch: | Press and release |
| Clear low battery: | Press and release mode switch on channel 2 (DXR-702 only) to clear low battery |